Skip to content

Your status page shows all green, clearly false

General Discussion by armstrongvds 6 replies 227 views
#1

Your status page was solid green for 45 minutes last Tuesday while my monitoring was screaming about packet loss to your Frankfurt location! This is the third time this year!

I run Ampere-based probes in three cities and they all showed 12-18% loss while your page showed "all systems operational." Insane value means nothing if I cannot trust the signal to escalate or wait it out. What is the actual refresh mechanism here? Manual? Automated? Runs circles around my patience, honestly.

one small ping for man...
#2

This is very common problem, my friend 😂 In Brazil we make a test with status page and real monitoring, many times is different! I think the green light is manual update and someone forget, or maybe the check is too simple, just ping and not real HTTP test? You need to push them for better! Is very good when provider is honest about problem!

ping so high I wave back
#3

Manual updates. Always lag. By design or negligence. Never sure. The worst is when they go green during the incident. Then back red after. Then green again. No credibility left. I have seen pages stay green for hours while tickets get auto-responses about known issues. At that point the page is worse than useless. It is active misdirection...

2 #4

You called a phone number, got a human, they told you straight. I ran a small colo then and our "status system" was a whiteboard in the NOC. Customers who toured the facility saw it, appreciated the honesty. They don't make them like that anymore. Now everything is automation theater, dashboards that refresh but do not reflect. The human layer got stripped out and we pretend a green dot replaces accountability.

SPARCstation 20, still serving HTTP
1 #5
armstrongvds said:
I run Ampere-based probes in three cities and they all showed 12-18% loss while your page showed "all systems operational." Insane value...

I have been in their DC, they are on 15A 120V rails, Supermicro 2U nodes, about 40 racks. The status page is likely tied to their core router ICMP, not the actual host switches. If the edge is clean but the TOR is dropping, you get this gap. Classic monitoring architecture problem. I told their lead tech about it six months ago, he said they were "evaluating solutions." Translation: no budget, no timeline. Typical for that generation of hardware, no out-of-band management on the host switches either — https://prometheus.io would need node-exporter on those TORs anyway.

visit twice: install and decom
10 #6

This is exactly why you run your own monitoring!!! Never trust the provider's word!!! What if they are compromised and the green status is itself a deception?!!! I have seen this in threat actor playbooks, maintain facade while exfiltrating!!! You need independent verification, fail2ban on your endpoints, outbound firewall rules, and a dead man's switch for DNS failover!!! What could go wrong: they get owned, you trust the green light, you do not rotate credentials in time, now you are collateral damage!!! 👀

airgapped, encrypted, faraday'd, still worried
#7

Guys, anyone know if they use off-the-shelf status page or custom build? I am looking for solution for my small brand, need something reliable but not expensive. This thread shows what NOT to do. Any leads? 🙏 Also margins on white-label status page service, is there demand?

your margin is my opportunity

Post a reply

You need an account to reply. Log in or register to join the conversation.

Post reply Preview Save draft